Stainless Steel Carto Punch

Simple design!  Punch your own cartos.

Made of stainless steel with a hardened steel tip.

Includes rubber wrist strap. Keyring hole.

From Siam Mods!

Customer Reviews:

I would've rate it 5 but I nearly wasted at least 4 fresh carto's and 6 mL of juices before I finally firgured it out!!! The carto puncher pin for
this is a lot bigger than the standard one so you will only need to punch one hole rather than two holes, TRUST ME!!! Making small holes does not
penatrate the cartomizer all the way through, and if you make it any bigger, it's way too big... Most importantly, making two holes will flood your
carto very easily, so stick it only once.rnOverall, it's a nice solid stainless steel ring and should last forever if taken care of properly.

Ok, I got my new tool. This thing works great. I cut the longer rubber from the Boge carto to the use as a guide to position the carto on the tool and
it works PERFECT. I can't see a better or easier way to punch holes in cartos. I love it. Thank You Clouds of Vapor

Nice heavy stainless ring, decent screw punch. It takes a while to figure out how many turns to make the right size hole as there is no
"pop" with this (used with 801 Fusion cartos). So the advice I would give is tighten to the spot you want the hole, then turn 3-3.5
complete revolutions, check your hole/dimple, and then re-tighten and do another half turn or so and repeat until your hole is of satisfactory size.
One thing about this is it will make big holes without too much warping of the cartos. Smaller holes require more care as described above. Good
product and miles ahead of saddle valves.

Great little punch for quick carto punching! Easy to use and fairly intuitive; even a newb like me can make perfect punches almost every time! Great
price, good quality and construction! COV put out a great product at a very reasonable price.